Cisco SFS 7008 Manual de usuario descargar pdf (Pagina 45)

Upgrade the Image with the CLI

To upgrade the image of the Controller card with the Command Line Interface, refer to “Upgrading a

Controller Card with the CLI” on page 57 and the following document:

• CLI Reference Guide

Upgrade the Image with the Chassis Manager

To upgrade the system image with the Chassis Manager web GUI, refer to the following document:

• Chassis Manager User Guide

Upgrade the Image with the Element Manager

To upgrade the system image with the optionally licensed Element Manager GUI, refer to the following

documents:

• Element Manager User Guide

Line Interface Management Modules (LIM)

About LIM Cards

Refer to “Line Interface Modules (LIM)” on page 19 for specific information about the LIM modules.

About a Failed LIM Module

If you believe a line interface module has failed, contact technical support.

Refer to “LIM Status LEDs” on page 75 and “Monitor the Cards” on page 79 for monitoring

information.

Locating a Failed LIM Module

The Line Interface Management modules are located on the back of the chassis. Refer to Figure 1-2 for

a diagram of the chassis.

Removing a LIM Card

1. Ground yourself appropriately.

2. Verify that you have a means of covering the slot before removing the module. Do not remove the

module unless you have a replacement or a blanking panel for the slot, as overheating may occur.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 107 108

Sin comentarios

Cisco SFS 7008 Manual de usuario Pagina 45