Cisco Explorer 8300 Guía de usuario descargar pdf (Pagina 30)

ADD STORAGE WITH A SATA HARD DISK DRIVE (OPTIONAL)

CONNECTING THE SATA DEVICE TO THE DVR

When a new SATA device is detected by the DVR unit, one of the following banners

appears, indicating that you need to format the device to work with the DVR.

Follow the on-screen instructions to format the device.

Because your SATA drive was formatted to work with your DVR unit, should you need

to disconnect, then reconnect the SATA hard disk drive to your DVR, one of the

following banners appears, indicating that the external device was properly

connected.

Press

to close the banner.

IMPORTANT! Do not power down the SATA drive while the DVR is powered on.

Doing so may result in lost or stopped recordings.

WARNING: Avoid electric shock. Unplug all electronic devices

before connecting or disconnecting any device cables to the DVR.

On the 8300-series DVRs, you can use a Serial ATA (SATA) hard disk drive for

increased recording capability. Contact your service provider for a list of approved

hard drive models that you can use with the 8300s.

IMPORTANT! You cannot choose between recording to the internal DVR

hard drive or recording to the SATA drive. If a SATA drive is connected to

the DVR, a program is automatically recorded to the hard drive with the

most available space. Recordings are not split across both the internal and

external drives.

Note: Recordings stored on the SATA drive can only be played back on the

DVR originally connected to the SATA drive. For instance, you cannot record

programs to the SATA drive, remove the drive, and then connect the drive to

a different DVR for playing back programs.

For instructions for connecting a SATA hard disk drive to the DVR, refer to the

connectivity guide for your DVR model.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

Sin comentarios

Cisco Explorer 8300 Guía de usuario Pagina 30