Cisco Explorer 8550HDC Guia de preparacion descargar pdf (Pagina 48)

Installation & Setup

Configuring Allégro systems

Before you can begin operations, you must configure each Allégro and make it available on your local

network. Specifically, you may have to:

• access the Allégro

• configure network and other settings

• set up streaming relays

• apply your changes and perform a readiness check

Accessing the Allégro

The Allégro has a built-in Web-based management utility. This utility is available as soon as the system is

powered up, and can be used to configure the system using a Web browser on any PC or laptop, provided

the PC or laptop can reach the Allégro’s IP address.

To access the Allégro system:

1. Configure your Client PC or laptop with an IP address in the same range as the IP address of the Allégro.

See “Configuring a Client PC or Laptop” on page 18.

2. Open a Web browser and type the Allégro’s default IP address (see “Network Configuration” on

page 11), specifying a connection on port 8080:

http://10.3.0.7:8080/

The Allégro Startup Page appears:

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 109 110

Sin comentarios

Cisco Explorer 8550HDC Guia de preparacion Pagina 48