Cisco 3825 Manual de usuario Pagina 268
- Pagina / 358
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
A-136
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
xconnect logging redundancy
xconnect logging redundancy
To enable system message log (syslog) reporting of the status of the xconnect redundancy group, use the
xconnect logging redundancy command in global configuration mode. To disable syslog reporting of
the status of the xconnect redundancy group, use the no form of this command.
xconnect logging redundancy
no xconnect logging redundancy
Syntax Description This command has no arguments or keywords.
Defaults Syslog reporting of the status of the xconnect redundancy group is disabled.
Command Modes Global configuration
Command History
Usage Guidelines Use this command to enable syslog reporting of the status of the xconnect redundancy group.
Examples The following example enables syslog reporting of the status of the xconnect redundancy group and
shows the messages that are generated during switchover events:
Router# config t
Router(config)# xconnect logging redundancy
Router(config)# exit
Activating the Primary Member
00:01:07: %XCONNECT-5-REDUNDANCY: Activating primary member 10.55.55.2:1000
Activating the Backup Member:
00:01:05: %XCONNECT-5-REDUNDANCY: Activating secondary member 10.55.55.3:1001
Related Commands
Release Modification
12.0(31)S This command was introduced.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.4(11)T This command was integrated into Cisco IOS Release 12.4(11)T.
12.4(16)MR This command was integrated into Cisco IOS Release 12.4(16)MR.
Command Description
xconnect Binds an Ethernet, 802.1q VLAN, or Frame Relay attachment circuit
to an L2TPv3 PW for xconnect service and enters xconnect
configuration mode.
- Software Configuration Guide 1
- CONTENTS 3
- Contents 4
- Document Revision History 7
- Objectives 7
- Audience 8
- Organization 8
- Conventions 8
- Related Documentation 9
- Guidelines 10
- Edge Router 11
- OL-15667-03 12
- Introduction 12
- MPLS/IP or L2TPv3 15
- Pseudowire 15
- Emulated Circuit 15
- Cisco IOS Software Features 16
- Software Features 17
- Redundancy Support 17
- MIB Support 20
- Limitations and Restrictions 21
- Structure-aware TDM CESoPSN 26
- ATM N-to-One VCC Cell Mode 27
- ATM AAL5 CPCS-SDU Mode 28
- ATM One-to-One VCC Cell Mode 28
- Cell Packing 29
- PVC Mapping 29
- ATM Port Cell Relay Service 30
- ATM VCC Cell Relay Service 30
- ATM AAL5-SDU Mode 31
- Asymmetric PWE3 32
- Ethernet over MPLS 33
- PWE3 over MLPPP 34
- PWE3 Redundancy 34
- TDM PWE3 Redundancy 35
- ATM PWE3 Redundancy 35
- Ethernet PWE3 Redundancy 35
- ATM Cell Switching 36
- Optimization over IP 37
- Behavior Changes 42
- UMTS QoS 43
- • GSM Shorthaul Interface 44
- Cisco IOS Software Basics 47
- Understanding Command Modes 48
- Undoing a Command or Feature 49
- First-Time Configuration 51
- Slot and Port Numbering 52
- Setup Command Facility 53
- Configuring Global Parameters 54
- Completing the Configuration 57
- Command-Line Interface 59
- Before You Begin 60
- Clock-Related Commands 61
- Clock Source Command 62
- Show Controller Command 63
- Configuration Sequence 64
- Step 1 Enter enable mode 65
- Enabling the GE Interface 67
- Configuring E1 Controllers 69
- Configuring T1 Controllers 70
- Creating a Multilink Bundle 73
- Handling PFC and ACFC 74
- Configuring ACFC 75
- Configuring GSM-Abis Links 78
- Configuring UMTS Links 82
- Configuring Redundancy 86
- Configuring for SNMP Support 91
- Configuration Sequence 94
- <group-number> 100
- Configuring UMTS QoS 104
- Creating a Class Map 105
- Creating a Policy Map 105
- Configuring Satellite Support 116
- Saving Configuration Changes 119
- !--- PVCs needed will vary 122
- BSC/RNC Configuration 123
- !--- Set VTY password 126
- !server 126
- Where to Go Next 131
- Where to Go Next 132
- Command Reference 133
- Command Description 146
- clear gsm-abis 147
- clear umts-iub 149
- gsm-abis congestion abate 154
- gsm-abis congestion onset 160
- gsm-abis jitter 162
- ip local interface 171
- ip rtp header-compression 173
- The passive Keyword 174
- The iphc-format Keyword 174
- The ietf-format Keyword 174
- Support for Serial Lines 174
- ip tcp header-compression 176
- Related Commands 180
- • “acceptable” to “warning” 181
- • “warning” to “overloaded” 181
- • “warning” to “acceptable” 181
- • “overloaded” to “warning” 181
- keepalive 188
- Keepalive Time Interval 189
- Line Failure 189
- Dropped Packets 189
- load-interval 191
- mpls ip 195
- • Data encapsulation type 197
- • Control protocol 197
- • Sequencing 197
- pseudowire-class 198
- sequencing 203
- show cem circuit 207
- show cem platform 209
- show connection 211
- show gsm-abis errors 216
- show l2tp session 224
- show l2tp tunnel 226
- show mpls l2transport vc 227
- Example 1: 236
- Example 2 236
- Example 3 236
- Example 1 239
- Example 3 with IMA 240
- show xconnect all 244
- • UP—The segment is up 246
- • DN—The segment is down 246
- standalone 251
- Router# standalone 251
- standby use-interface 252
- xconnect 265
- Keyword ignore-vpi-vci 266
- Activating the Primary Member 268
- Activating the Backup Member: 268
- Configuration Examples 269
- Asymmetric PWE3 Configuration 270
- PWE3 over MLPPP Configuration 289
- PWE3 Redundancy Configuration 298
- TDM over MPLS Configuration 304
- ATM over MPLS Configurations 309
- ATM over L2TPv3 Configuration 316
- GSM Only Configuration 323
- UMTS Only Configuration 327
- GSM + UMTS Configuration 331
- With IMA 336
- With IMA and PVC routing 342
- Via Satellite 348
- GSM Congestion Management 351
- UMTS Congestion Management 352
Relacionado con productos y manuales para Hardware Cisco 3825
Hardware Cisco 3745 Manual de usuario
(32 paginas)
(32 paginas)
Hardware Cisco 12404 Manual de usuario
(18 paginas)
(18 paginas)
Hardware Cisco 3600 Manual de usuario
(18 paginas)
(18 paginas)
Hardware Cisco BEFCMU10 Manual de usuario
(30 paginas)
(30 paginas)
Hardware Cisco 545 Serial Manual de usuario
(74 paginas)
(74 paginas)
Hardware Cisco DPQ2202 Manual de usuario
(38 paginas)
(38 paginas)
Hardware Cisco DPQ3212 Manual de usuario
(40 paginas)
(40 paginas)
Hardware Cisco 7200 VXR Manual de usuario
(48 paginas)
(48 paginas)
Hardware Cisco OL-15491-01 Manual de usuario
(268 paginas)
(268 paginas)
Hardware Cisco 1711 Manual de usuario
(12 paginas)
(12 paginas)
Hardware Cisco XR 12406 Manual de usuario
(252 paginas)
(252 paginas)
Hardware Cisco WUSB600N Manual de usuario
(43 paginas)
(43 paginas)
Hardware Cisco 12000 Series Manual de usuario
(10 paginas)
(10 paginas)
Hardware Cisco 7200 Manual de usuario
(50 paginas)
(50 paginas)
Hardware Cisco WUSB54GC Manual de usuario
(33 paginas)
(33 paginas)
Hardware Cisco 3825 Series Manual de usuario
(20 paginas)
(20 paginas)
Hardware Cisco 2000 Manual de usuario
(6 paginas)
(6 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.053 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales