Cisco 7100 Series Manual de usuario descargar pdf (Pagina 19)

Start the System (continued)

Last reset from power-on

X.25 software, Version 3.0.0.

2 FastEthernet/IEEE 802.3 interface(s)

2 ATM network interface(s)

125K bytes of non-volatile configuration memory.

8192K bytes of Flash PCMCIA card at slot 1 (Sector size 128K).

8192K bytes of Flash internal SIMM (Sector size 256K).

Enter yes or press Return to enter the initial conﬁguration dialog:

--- System Configuration Dialog ---

Would you like to enter the initial configuration dialog? [yes/no]: yes

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Basic management setup configures only enough connectivity

for management of the system, extended setup will ask you

to configure each interface on the system

Enter yes or press Return to see the current interface summary:

First, would you like to see the current interface summary? [yes]: yes

Any interface listed with OK? value “NO” does not have a valid configuration

Interface IP-Address OK? Method Status Protocol

FastEthernet0/0 unassigned NO unset up up

FastEthernet0/1 unassigned NO unset up up

ATM1/0 unassigned NO unset down down

ATM2/0 unassigned NO unset down down

Note: Theexampleshowsa router at ﬁrst-time startup; thatis,nothingisconﬁgured.The type

of interfaces vary depending on the type of Cisco 7100 series router you are using and the type

of modular port adapter installed in the router.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Cisco 7100 Series Manual de usuario Pagina 19