Cisco MC3810-APM-FXO= Ficha de datos descargar pdf (Pagina 14)

Configuring Voice Ports

Analog Voice Ports Configuration Task List

VC-48

Cisco IOS Voice, Video, and Fax Configuration Guide

E&M

Router(config-voiceport)# signal {wink-start |

immediate-start | delay-dial}

The keywords are as follows:

• wink-start—(default) Indicates that the

calling side seizes the line, then waits for a

short off-hook wink from the called side

before proceeding.

• immediate-start—Indicates that the calling

side seizes the line and immediately proceeds;

used for E&M tie trunk interfaces.

• delay-dial—Indicates that the calling side

seizes the line and waits, then checks to

determine whether the called side is on-hook

before proceeding; if not, it waits until the

called side is on-hook before sending digits.

Used for E&M tie trunk interfaces.

Note Configuring the signal keyword for one

voice port on a Cisco 2600 or 3600 series

router VIC changes the signal value for

both ports on the VIC.

Step 3

Router(config-voiceport)# cptone

locale

Selects the two-letter locale for the voice call

progress tones and other locale-specific

parameters to be used on this voice port.

Cisco routers comply with the ISO 3166 locale

name standards. To see valid choices, enter a

question mark (?) following the cptone command.

The default is us.

Step 4

Router(config-voiceport)# dial-type {dtmf | pulse}

(FXO only) Specifies the dialing method for

outgoing calls.

Step 5

Router(config-voiceport)# operation {2-wire | 4-wire}

(E&M only) Specifies the number of wires used

for voice transmission at this interface (the audio

path only, not the signaling path).

The default is 2-wire.

Step 6

Router(config-voiceport)# type {1 | 2 | 3 | 5}

(E&M only) Specifies the type of E&M interface

to which this voice port is connecting. See Table 5

on page 40 for an explanation of E&M types.

The default is 1.

Step 7

Cisco 1750 Router and 2600 and 3600 Series Routers

Router(config-voiceport)# ring frequency {25 | 50}

Cisco MC3810 Multiservice Concentrator

Router(config-voiceport)# ring frequency {20 | 30}

(FXS only) Selects the ring frequency, in hertz,

used on the FXS interface. This number must

match the connected telephony equipment and

may be country-dependent. If not set properly, the

attached telephony device may not ring or it may

buzz.

The keyword default is 25 on the Cisco 1750

router, 2600 and 3600 series routers; and 20 on the

Cisco MC3810 multiservice concentrator.

Command Purpose

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 81 82

Comentarios a estos manuales

Sin comentarios

Cisco MC3810-APM-FXO= Ficha de datos Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Componentes del interruptor de red Cisco MC3810-APM-FXO=