Cisco 1503 Manual de usuario descargar pdf (Pagina 7)

Release Notes for the Cisco 1503 Micro Hub for Software Release 2.01 7

Hub ID Numbers

Wall-Mounting the Hub

The Cisco Micro Hub can be wall-mounted using two number 6, 3/4-inch screws and the molded

mounting brackets on the bottom of the hub. You must provide the screws. We recommend using

pan-head or round-head screws.

Figure 2 Wall-Mount Brackets—Bottom of Hub

To mount the hub on a wall or other surface:

Step 1 Install the two screws 3.75 inches (9.52 centimeters) apart (horizontally) on a wall or

other vertical surface.

The screws should protrude 0.25 inches (0.64 centimeters) from the surface of the wall.

Step 2 Hang the hub on the screws with either the left side or right side mounting brackets so

that:

• The LEDs are visible to the user—The LEDs indicate the hub operating status, so the

LEDs should be easily visible.

• The power supply does not hang from its cable—If the power supply is not supported,

it will disconnect from the cable that connects it to the hub.

Caution If you install the screws in drywall, use hollow wall anchors (1/8 inch by 5/16 inch) to

secure the screws. If the screws are not properly anchored, the strain of the cables connected to the

hub rear panel connectors could pull the hub from the wall.

Front panel of hub

H10652

3.75"

(9.52 cm)

Mounting

bracket

Mounting

bracket

Mounting

bracket

Bottom

of hub

Mounting

bracket

1 2 3 4 5 6 7 8 9 10

Sin comentarios

Cisco 1503 Manual de usuario Pagina 7