
Cisco Systems, Inc.
All contents are Copyright © 1992–2001 Cisco Systems, Inc. All rights reserved. Important Notices and Privacy Statement.
Page 8 of 11
Technical Specifications
Performance
• 24 Gbps switching fabric
• 12 Gbps maximum forwarding bandwidth
• 17 Mpps forwarding rate for 64-byte packets
• 2 MB memory architecture shared by all ports
• 32 MB DRAM and 8 MB Flash memory
• Configurable up to 12000 MAC addresses
Management
• RFC 1213
• IF MIB
• CISCO-CDP-MIB
• CISCO-IMAGE-MIB
• CISCO-FLASH-MIB
• OLD-CISCO-CHASSIS-MIB
• CISCO-PAGP-MIB
• CISCO-VTP-MIB
• CISCO-HSRP-MIB
• OLD-CISCO-TS-MIB
• BRIDGE-MIB (RFC1493)
• CISCO-VLAN-MEMBERSHIP-MIB
• CISCO-VLAN-IFINDEX-RELATIONSHIP-MIB
• CISCO-STACK-MIB (only a subset of the
available MIB objects are implemented; not all
objects are supported)
• RMON 1 MIB
• IGMP MIB
• PIM MIB
• CISCO-STP-EXTENSIONS-MIB
• OSPF-MIB (RFC 1253)
• IPMROUTE-MIB
• CISCO-MEMORY-POOL-MIB
• CISCO-RTTMON-MIB
• CISCO-PROCESS-MIB
• OLD-CISCO-SYS-MIB
• CISCO-CONFIG-MAN-MIB
Standards
• IEEE 802.1x support (planned future software
support)
• IEEE 802.3x full duplex on 10BaseT, 100BaseTX,
and 1000BaseT ports
• IEEE 802.1D Spanning-Tree Protocol
• IEEE 802.1p CoS Prioritization
• IEEE 802.1Q VLAN
• IEEE 802.3 10BaseT specification
• IEEE 802.3u 100BaseTX specification
• IEEE 802.3ab 1000BaseT specification
• IEEE 802.3z 1000BaseX specification
• 1000BaseX (GBIC)
–
1000BaseSX
–
1000BaseLX/LH
–
1000BaseZX
• RMON I and II standards
Y2K
• Y2K compliant
Connectors and Cabling
• 10BaseT ports: RJ-45 connectors; two-pair Category
3, 4, or 5 unshielded twisted-pair (UTP) cabling
• 100BaseTX ports: RJ-45 connectors; two-pair
Category 5 UTP cabling
• 1000BaseT ports: RJ-45 connectors; two-pair
Category 5 UTP cabling
• 1000BaseSX, -LX/LH, -ZX GBIC-based ports: SC
fiber connectors, single-mode or multimode fiber
• GigaStack GBIC ports: copper-based
Cisco GigaStack cabling
• Management console port: 8-pin RJ-45 connector,
RJ-45-to-RJ-45 rollover cable with RJ-45-to-DB9
adaptor for PC connections. For terminal connections,
use RJ-45-to-DB25 female DTE adaptor (can be
ordered separately from Cisco, part number
ACS-DSBUASYN=)
Comentarios a estos manuales