Cisco 15454-DS1-14= - 1.544Mbps Expansion Module Especificaciones Pagina 17

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 56
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 16
17
Cisco ONS 15454 Product Overview, R3.3
May 2002
Cisco ONS 15454 Product Overview
Cisco Transport Controller
Optical Protection
The ONS 15454 supports 1+1 protection to create redundancy for optical cards
and spans. With 1+1 protection, one optical port can protect another optical port;
therefore, in any two high-speed slots a single working card and a single dedicated
protect card of the same type (for example, two OC-48 cards) can be paired for
protection. If the working port fails, the protect port takes over. 1+1 span
protection can be either revertive or non-revertive.
Because the OC-3 card is a multiport card, port-to-port protection is available.
The ports on the protect card support the corresponding ports on the working card.
Protection Switching
The ONS 15454 supports revertive and non-revertive, unidirectional or
bidirectional switching for optical signals. 1:N electrical protection is always
revertive and bidirectional; 1:1 electrical protection is also bidirectional but
provides the revertive or non-revertive option.
When a failure occurs and automatic protection switching (APS) switches the
signal from the working card to the protect card, non-revertive switching does not
revert the traffic to the working card automatically when the working card reverts
to active status. When a failure is cleared, revertive switching automatically
switches the signal back to the working card after the provisionable revertive time
period has elapsed.
When a failure occurs to a signal that is provisioned as bidirectional, both the
transmit and receive signals are switched away from the point of failure (the port
or card). A unidirectional signal switches only the failure direction, either
transmit or receive.
Cisco Transport Controller
Cisco Transport Controller (CTC) is a software program that is automatically
downloaded from the TCC+ card to your workstation when you connect to the
ONS 15454. CTC gives you control of Operation, Administration, Maintenance,
and Provisioning (OAM&P) activities for the ONS 15454.
Vista de pagina 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 55 56

Comentarios a estos manuales

Sin comentarios