Cisco 1710 Especificaciones descargar pdf (Pagina 62)

Chapter 4 Configuring Routing Between VLANs with IEEE 802.1Q Encapsulation

Examples of IEEE 802.1Q Encapsulation Configuration

4-6

Cisco 1710 Security Router Software Configuration Guide

78-12696-01

Defining the VLAN Encapsulation Format

To define the encapsulation format as IEEE 802.1Q, use the following commands

in interface configuration mode:

Configuring NetWare on the Subinterface

After you enable NetWare globally and define the VLAN encapsulation format,

you may need to enable the subinterface by specifying the NetWare network

number. Use this command in interface configuration mode:

Examples of IEEE 802.1Q Encapsulation

Configuration

This section provides configuration examples for each of the protocols described

in this chapter. The section provides the examples for the following:

• Configuring AppleTalk over IEEE 802.1Q

• Configuring IP Routing over IEEE 802.1Q

• Configuring IPX Routing over IEEE 802.1Q

Command Purpose

Step 1

interface fastethernet

port.subinterface-number

Specifies the subinterface on which IEEE 802.1Q

will be used.

Step 2

encapsulation dot1q vlan-identifier

Defines the encapsulation format as IEEE 802.1Q

and specifies the VLAN identifier.

Command Purpose

ipx network network

Specifies the IPX network number.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 87 88

Sin comentarios

Cisco 1710 Especificaciones Pagina 62