Cisco 2600XM Series Guía de instalación descargar pdf (Pagina 4)

Procedure Using ROMmon. This procedure does not require the use of a Trivial File Transfer

Protocol (TFTP) server.

Error Messages

The Error Message Decoder tool (

registered customers only

) allows you to check the meaning of an error

message. Error messages appear on the console of Cisco products, usually in the following form:

%XXX−n−YYYY : [text]

Following is an example error message:

Router# %SYS−2−MALLOCFAIL: Memory allocation of [dec] bytes failed from [hex],

pool [chars], alignment [dec]

Some error messages are informational only, while others indicate hardware or software failures and require

action. The Error Message Decoder Tool provides an explanation of the message, a recommended action (if

needed), and if available, a link to a document that provides extensive troubleshooting information about that

error message.

Conventions

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

Modules and Cards

The documents below can help you verify which module/card is supported:

For WAN Interface Card (WIC) compatibility information, refer to the WIC Hardware Compatibility

Matrix.

•

For Voice Interface Card (VIC) and Voice WAN Interface Card (VWIC) compatibility information,

refer to the Voice Hardware Compatibility Matrix.

•

Refer to Cisco 2600 Series Multiservice Platforms: Relevant Interfaces and Modules and Cisco

Network Modules Hardware Installation Guide for more information.

•

Troubleshooting Modem Modules

The 2600 Series Router only supports the following internal analog modem components:

WAN Interface Cards: WIC−1AM or WIC−2AM•

Modem Network Modules: NM−8AM, NM−16AM•

Refer to the following documents for more details:

Understanding Analog Modem Network Modules (NM−8AM / NM−16AM)•

Understanding Analog Modem WAN Interface Cards (WIC−1AM or WIC−2AM)•

Note: The 2600 Series Router does not support any internal digital modems.

Cisco − Hardware Troubleshooting for the Cisco 2600 Series Router

1 2 3 4 5 6 7 8 9 ... 15 16

Sin comentarios

Cisco 2600XM Series Guía de instalación Pagina 4