Cisco 6260 Guía de instalación descargar pdf (Pagina 114)

3-26

Cisco 6260 Hardware Installation Guide

OL-2365-02

Chapter 3 Installing a Cisco 6260 with a POTS Splitter Configuration

Installation Procedures

The enable password is used when you do not specify an

enable secret password, with some older software versions, and

some boot images.

Enter enable password [lab]: lab

The virtual terminal password is used to protect

access to the router over a network interface.

Enter virtual terminal password [lab]:

Configure SNMP Network Management? [no]:

Configure IP? [yes]:

Configure IGRP routing? [yes]: no

Configuring interface parameters:

Do you want to configure ATM0/0 interface? [yes]:

Configure IP on this interface? [yes]:

IP address for this interface [70.0.0.2]:

Subnet mask for this interface [255.0.0.0] :

Class A network is 70.0.0.0, 8 subnet bits; mask is /8

Do you want to configure Ethernet0/0 interface? [yes]:

Configure IP on this interface? [yes]:

IP address for this interface [172.27.32.156]:

Subnet mask for this interface [255.255.0.0] :

Class B network is 172.27.0.0, 16 subnet bits; mask is /16

Do you want to configure ATM0/1 interface? [yes]: