Cisco 675E Guía de usuario descargar pdf (Pagina 46)

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices

Update the CBOS Prompt

5-46

Cisco 600 Series Installation and Operation Guide

78-11190-01

Step 5 Enter:

set ppp wan0-0 ipcp 0.0.0.0

Step 6 Enter:

set ppp wan0-0 dns 0.0.0.0

Step 7 To enable NAT, enter:

set nat enable

Step 8 To enable the DHCP server, enter:

set dhcp server enable

Step 9 To save your changes, enter:

write

Step 10 To reboot the CPE, enter:

reboot

Update the CBOS Prompt

The default CBOS prompt is cbos#. You can change this prompt to a unique

subscriber identifier, as shown in the following example.

Step 1 Log on to CBOS using either the serial or Telnet interface. See the “Telnet”

section on page 5-24 for information on how to use Telnet to log on to the CBOS.

Step 2 To change the default prompt to c678, enter:

set prompt c678

Note The prompt is limited to seven characters.

Step 3 The following prompt now appears:

c678#

1 2 ... 41 42 43 44 45 46 47 48 49 50

Sin comentarios

Cisco 675E Guía de usuario Pagina 46