Cisco 7246 - uBR Router Especificaciones descargar pdf (Pagina 9)

Attach the Rack-Mount Brackets to the Rear of the Chassis

To install the rack-mount brackets on the chassis for a rear rack-mount configuration, complete the following steps:

Step 1 Locate the threaded holes in the rear sides of the chassis.

Step 2 Align the first rack-mount bracket to the threaded holes in the right side of the chassis. See Figure 4.

Figure 4 Installing the Rack-Mount Brackets on the Rear of the Chassis

Note There are eight holes in each of the rack-mount brackets for the Cisco uBR7246VXR. You may use either set

of four holes to align the bracket to the threaded holes in the sides of the chassis.

Step 3 Thread the four M4 x 6-mm Phillips flathead screws through the rack-mount bracket and into the side of the chassis.

Use a number 2 Phillips screwdriver to tighten the screws.

Step 4 Repeat Step 1 through Step 3 for the other rack-mount bracket.

Step 5 See the “Installing the Cable-Management Brackets” section on page 11 for cable management bracket instructions.

Attach the Rack-Mount Brackets to the Front of the Chassis

To install the rack-mount brackets on the chassis for a front rack-mount configuration, complete the following steps.

Step 1 Locate the threaded holes in the front sides of the chassis.

Step 2 If you want the front of the chassis flush with the front of the rack, align the first rack-mount bracket to the threaded

holes in the right side of the chassis as shown in Figure 5

If you want the front of the chassis protruding from the rack, align the first rack-mount bracket to the threaded holes

in the right side of the chassis as shown in Figure 6.

Note There are eight holes in each of the rack-mount brackets. You may use either set of four holes to align the bracket to

the threaded holes in the sides of the chassis.

Step 3 Thread the four M4 x 6-mm Phillips flathead screws through the bracket and into the side of the chassis. Use a

number 2 Phillips screwdriver to tighten the screws.

Step 4 Repeat Step 1 through Step 3 for the other rack-mount bracket.

103560

Rack-mount

bracket

Rack-mount

bracket

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Sin comentarios

Cisco 7246 - uBR Router Especificaciones Pagina 9