Cisco CISCO7576 Especificaciones Pagina 22

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 30
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 21
22 Cisco 7513 and Cisco 7576 Chassis Replacement and Upgrade Instructions
Replacing or Upgrading the Chassis
Step 7 Place the processor module in the same slot position in the new chassis and align the
notches along the edge of the carrier with the grooves in the slot. (See Figure 9a.)
Step 8 While keeping the carrier at a 90-degree orientation to the backplane, carefully slide the
carrier into the slot until the back of the faceplate makes contact with the ejector levers,
and then stop. (See Figure 9b.)
Do not use unnecessary force when installing processor modules. Always guide the
carrier into the slot only until the carrier faceplate makes contact with the ejector levers;
then use the ejector levers to complete the insertion.
Step 9 Using the thumb and forefinger of each hand to pinch each ejector, simultaneously push
both ejectors inward (toward the carrier handle) until they snap into place and are at a full
90-degree orientation to the faceplate. (See Figure 9c.) The carrier ears (the ends of the
faceplate) should be flush against the chassis.
Step 10 Use a screwdriver to tighten the two captive screws to prevent the processor module from
becoming partially dislodged from the backplane and to ensure proper EMI shielding.
Step 11 Repeat Steps 2 through 10 for the remaining interface processors.
Figure 10 Handling a Processor Module
Note Leave the interface processor filler installed in any unfilled interface processor slots.
This completes the processor module removal and replacement procedure. If you need to install the
new chassis in an equipment rack, proceed to the “Installing the New Chassis in the Rack” section
on page 15. Otherwise, proceed to the next section to check the installation.
H1355a
Vista de pagina 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29 30

Comentarios a estos manuales

Sin comentarios

Kenwood MFJ-286 manuales

Manuales del propietario y guías del usuario para Micrófonos Kenwood MFJ-286.
Ofrecemos 1 manuales en pdf Kenwood MFJ-286 para descargar gratis por tipos de documentos: Manual de usuario


Kenwood MFJ-286 Manual de usuario (1 paginas)


Marca: Kenwood | Categoria: Microphones | Tamaño: 0.00 MB |

 

Tabla de contenidos





Más productos y manuales para Micrófonos Kenwood

Modelos Tipo de documento
KFC-W3010 Manual de usuario   Kenwood KFC-W3010 User Manual [es] , 2 paginas
KFC-XW1224D Manual de usuario    Инструкция по эксплуатации Kenwood KFC-XW1224D, 2 paginas
KFC-S502P Manual de usuario    Инструкция по эксплуатации Kenwood KFC-S502P, 2 paginas
KSC-8803 Manual de usuario   Kenwood KSC-8803 User Manual, 2 paginas
KSC-9903 Manual de usuario   Kenwood KSC-9903 User Manual, 2 paginas