
CCNA Exploration
LAN Switching and Wireless: Basic Wireless Concepts and Configuration PT Activity 7.5.2: Challenge Wireless WRT300N
All contents are Copyright © 1992–2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 2 of 8
VLAN Table
Learning Objectives
Perform basic router configurations.
Perform switch configurations.
Connect to the Linksys WRT300N router.
Access the WRT300N.
Configure IP settings for the Linksys WRT300N.
Configure DHCP settings.
Configure basic wireless settings.
Enable wireless security.
Managing and securing the web utility of the router.
Configure WRS2.
Creating and verifying full connectivity.
Configure port security.
Introduction
In this activity, you will configure a Linksys WRT300N, port security on a Cisco switch, and static routes
on multiple devices. Make note of the procedures involved in connecting to a wireless network because
some changes involve disconnecting clients, which may then have to reconnect after making changes to
the configuration.
Task 1: Perform Basic Router Configurations
Step 1. Perform basic router configurations.
Configure R1 according to the following guidelines:
Configure router hostname.
Disable DNS lookup.
Configure an encrypted privileged EXEC mode password of class.
Configure a password of cisco for console connections.
Configure a password of cisco for vty connections.
Step 2. Configure router interfaces.
Configure Loopback0, FastEthernet 0/0, 0/1, and any subinterfaces listed in the addressing table. Before
configuring the IP addresses on the the subinterfaces, encapsulation must be set to 802.1Q. The VLAN
ID is identified by the subinterface number.
Verify the interfaces are up and their IP Addresses are correect with the show ip interfaces brief
command.
Comentarios a estos manuales