Cisco ADSL Modem Router Manual de usuario descargar pdf (Pagina 5)

4. Wait for about 30 seconds.

5. Plug in the modem’s power cord. If there is an additional power switch required

to power on your modem, be sure to use it to apply power and turn on the modem.

6. Observe the indicator lights located on the modem and wait for the lights to stop

blinking. A light indicating Power as well as DSL (or Internet, Online, Ready,

etc.) should become solid to indicate a connection to your Internet Service

Provider. The names of modem lights will vary depending on modem brand and

model.

7. Next, plug in the router’s power cord. After a few seconds, the Internet light (or

WAN lights) on the front of the router as well as additional lights on your modem

should turn on to indicate a connection.

8. Turn on your computer.

STEP 6: Check the Connection

Follow these steps to check your connection to your Internet Service Provider.

1. On the computer that is connected to the Linksys Router, open a web browser

such as Internet Explorer or Netscape.

2. Type http://192.168.1.1 into your browser’s Address or Location bar and click Go

or press the [Enter] key on your keyboard. The IP address 192.168.1.1 is the

default IP address of Linksys Routers.

3. A user name and password prompt will appear. Leave the user name field blank

(empty), and type in admin (lowercase) for the password. The password admin is

the default password of Linksys Routers.

4. Once logged in, the router’s web-based Setup utility should load. Click on the

Status tab to load the router’s Status page.

NOTE: The location of the Status tab will vary depending on router model and

firmware version:

5. In the Status page, look for a section labeled Login Status (or PPPoE Status

depending on router model and firmware version). This will indicate the status of

the connection.

1 2 3 4 5 6 7

Sin comentarios

Cisco ADSL Modem Router Manual de usuario Pagina 5