Cisco Aironet 1000 Series Guía de instalación descargar pdf (Pagina 13)

Priming the Access Point

This section describes the optional procedure for priming or staging your access point before it is

installed. Priming might be employed if the access point is to be installed in a difficult to access or

inaccessible location. Performing this procedure helps identify and eliminate potential problems in the

Ethernet and power areas before you install the access point in its final location.

Figure 6 illustrates a basic priming configuration for your access points.

Figure 6 Basic Priming Configuration

All access point configuration parameters are set on the controller. You can use the controller’s CLI or

web-browser interface. You can also use Cisco WCS to configure the access point.

Follow these steps to prime your access point:

Step 1 Ensure that a DHCP server is enabled on the subnet (typically on your switch). The access

points receives its IP address using DHCP Option 43.

The access point must be able to find the IP address of the controller using DHCP, DNS,

OTAP, or IP subnet broadcast. This guide describes the DHCP method to convey the

controller IP address. For other methods, refer to the product documentation. For information

about DHCP Option 43, see the “Configuring DHCP Option 43” section on page 15.

Controller

Layer 2/3

devices

Access

points

135670

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Sin comentarios

Cisco Aironet 1000 Series Guía de instalación Pagina 13