Cisco Catalyst Express 520 Manual de usuario descargar pdf (Pagina 3)

Four additional analog ports (FXO or FXS) can

be added via the built in WIC card slot on the

front of the box. System does offer a BRI port

option for PSTN connectivity for International

market. A flash slot is also provided for storage

of configuration.

On the front left there are three additional

connections; console, music on hold, and

wireless. Full CLI access to the IOS can be

obtained through the console port for any

configuration settings not covered in the GUI

interface.

Music on hold can be provided by an internal or

external source. If no source is plugged into the

1/8” audio jack on the front of the Cisco Unified

Communications 500 Series, the system will

default to an internal .AU file. Additional .AU

files can be loaded through the Cisco

Configuration Assistant.

The integrated wireless access point is optional.

It must be specified at time of ordering and

factory installed. It supports several security

settings including WEP, EAP, WPA, WPA-PSK,

WPA2 and WPA2-PSK. Authentication can also

be tied to an internal or external RADIUS. The

wireless was configured and two wireless

handsets were used to place calls.

Connecting the Cisco Catalyst Express 520

expansion switch will add eight additional auto

sensing 10/100 PoE Ethernet ports to the

system. The licensing for the endpoints is

embedded in the switch, simplifying upgrading.

The switch is shipped with a smart-assist feature

which enables plug-n-play expansion. Once the

switch was connected, the configuration was

adjusted automatically and new phones plugged

into the switch were automatically configured

and ready to use

Cisco Configuration Assistant

The Cisco Configuration Assistant provides an

interactive GUI interface for configuration and

modification of the Cisco Unified

Communications 500 Series. All of the main

features and functionality of the device can be

configured and maintained from this application.

The tool effectively lowers the bar to enable

rapid setup and deployment of even complex

environments. A system with all of the phone

features enabled and four endpoints was setup

and operational in under 15 minutes.

There are several visual feedback mechanisms

within the application which aid users in

configuration. The first area that was configured

was the telephony settings. Several of the fields

within the dialog boxes were outlined in red

indicated a problem with the values listed in the

fields. The text in some of the tabs across the

top was also in red indicating fields on those

pages also needed correction. If a specific field

was correct or the data was changed with a field,

it was outlined in green. The text on the tab for

that page also changed to green indicating

unsaved changes. All of these visual cues

decrease the learning curve on the required

parameters and help to eliminate configuration

errors. Since the application is interactive, as

changes are applied, the configuration on the

Cisco Unified Communications 500 Series is

updated immediately. There is no need to

reboot or re-start the process to make additional

changes. The application will not allow changes

to be saved if there are errors indicated by fields

outlined in red.

Figure 1: Configuration Interface

The application is divided into two panes. The

left pane provides a navigation tree for the

configuration, monitoring and maintenance

options that are available. The option presented

will be dependent upon the hardware found in

the initial discover process. The right pane

displays dialog boxes for setting the specific

details of each of the options as well as a

1 2 3 4 5 6

Comentarios a estos manuales

Sin comentarios

Cisco Catalyst Express 520 Manual de usuario Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cisco Catalyst Express 520