Cisco Ethernet switch Instrucciones de operaciones descargar pdf (Pagina 149)

Chapter 7. Cisco Systems IGESM configuration and network integration 135

Figure 7-6 Windows 2000 networking showing physical and logical interfaces on BladeServer1

Figure 7-7 Windows 2000 networking showing only physical interfaces on BladeServer2

From the CMD prompt (Start → Run → cmd → OK), execute the ipconfig command and

confirm that the desired interfaces have the desired IP configuration on each blade server

(make sure they are not reversed, where the IP address you want on the

Local Area

Connection

is not on the connection named Local Area Connection 2, assuming they have

not been renamed). For teamed interfaces, make sure that the IP address is on the expected

logical interface as reported by ipconfig.

Perform ping tests from the various boxes.

The following tests connectivity between blade servers on the same VLANs. Pings will only

travel up to the appropriate Cisco Systems IGESM and back to the other blade server (they

will not travel up to the aggregation switches).

򐂰 Ping from BladeServer1 to 10.1.10.2 (BladeServer2’s VLAN 10 connection)

򐂰 Ping from BladeServer1 to 10.1.20.2 (BladeServer2’s VLAN 20 connection)

The following tests connectivity through the Cisco Systems IGESMs and up to the 6500s:

򐂰 Ping from BladeServer1 to 10.1.10.254 (HSRP address on the 6500s)

򐂰 Ping from BladeServer1 to 10.1.15.254 (HSRP address on the 6500s)

򐂰 Ping from BladeServer1 to 10.1.20.254 (HSRP address on the 6500s)

򐂰 Ping from BladeServer1 to 10.1.25.254 (HSRP address on the 6500s)

򐂰 Ping from BladeServer2 to 10.1.10.254 (HSRP address on the 6500s)

򐂰 Ping from BladeServer2 to 10.1.20.254 (HSRP address on the 6500s)

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 265 266

Sin comentarios

Cisco Ethernet switch Instrucciones de operaciones Pagina 149