Cisco UBR7223 - uBR 7223 Modular Expansion Base Especificaciones descargar pdf (Pagina 38)

Installation Overview

PA-H HSSI Port Adapter Installation and Configuration

4-6

Figure 4-5 Port Adapter Installed in a Port Adapter Slot—Partial Port Adapter View

Step 11

Replace the screw in the rear of the port adapter slot. (See Figure 4-2 for its location.) Do

not overtighten this screw.

Step 12 Reinstall the Catalyst RSM/VIP2 in the system. Follow the steps in the Route Switch

Module Catalyst VIP2-15 and VIP2-40 Installation and Conﬁguration Note (Document

Number 78-4780-01) which shipped with your Catalyst RSM/VIP2.

Step 13 If disconnected, reconnect the interface cables to the port adapters.

This completes the procedure for installing a new port adapter or replacing a port adapter on a

Catalyst RSM/VIP2. To install the necessary cables and conﬁgure your PA-H, proceed to Chapter 8,

“Cable Installation and Interface Conﬁguration.”

H3152

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 71 72

Sin comentarios

Cisco UBR7223 - uBR 7223 Modular Expansion Base Especificaciones Pagina 38