Cisco Wide Area Virtualization Engine 274 Guía para resolver problemas descargar pdf (Pagina 567)

100

101

1-13

Cisco Wide Area Application Services Configuration Guide

OL-26579-01

Chapter 1 Configuring SNMP Monitoring

Preparing for SNMP Monitoring

Before you configure your WAAS network for SNMP monitoring, complete the following preparation

tasks:

• Set up the SNMP host (management station) that the WAAS devices will use to send SNMP traps.

• Determine if all your WAAS devices will be sending traps to the same host, or to different hosts.

Write down the IP address or hostname of each SNMP host.

• Obtain the community string used to access the SNMP agents.

• Determine if you want to create SNMP groups so you can restrict views by group.

• Determine what additional SNMP traps you need.

• Clock synchronization between the devices in a WAAS network is important. On each WAAS

device, be sure to set up a Network Time Protocol (NTP) server to keep the clocks synchronized.

Enabling SNMP Traps

To enable a WAAS device to send SNMP traps, follow these steps:

Step 1 From the WAAS Central Manager menu, choose Devices > device-name (or Device Groups >

device-group-name).

Step 2 Choose Configure > Monitoring > SNMP > General Settings. The SNMP General Settings window

appears. (See Figure 1-2.) Table 1-3 describes the fields in this window.

1 2 ... 562 563 564 565 566 567 568 569 570 571 572 ... 593 594

Comentarios a estos manuales

Sin comentarios

Cisco Wide Area Virtualization Engine 274 Guía para resolver problemas Pagina 567

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cisco Wide Area Virtualization Engine 274