Cisco WS-X6416-GE-MT - Interface Module - Expansion Manual de usuario Pagina 29

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 51
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 28
White Paper
All contents are Copyright © 1992–2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 29 of 51
Cisco Catalyst OS Cisco IOS Software
Catalyst OS config:
set port channel 3/1–8 2 desirable
set spantree portfast 3/1-8
set vlan 10 3/1-8
MSFC config:
int vlan 10
ip address 10.10.10.1 255.255.255.0
interface range fa3/1—8
no shut
channel-group 1 mode desirable
interface port-channel 1
switchport
switchport mode access
no shut
int vlan 10
ip address 10.10.10.1 255.255.255.0
Layer 3 EtherChannel Groups
True Layer 3 EtherChannel groups are only specific to an IP subnet, not to a Layer 2 VLAN. As
with the previously described routed interface, this is a concept only available in Cisco IOS
Software. The following is an example of the command line syntax for configuring a Layer 3
EtherChannel group.
Cisco Catalyst OS Cisco IOS Software
No Catalyst OS equivalent int range fa3/1—8
channel-group 1 mode desirable
interface port-channel 1
ip address 10.10.10.1 255.255.255.0
The following are some helpful show commands for EtherChannel groups on a Cisco IOS
Software system:
show etherchannel summary to view all EtherChannel groups states and ports on a Cisco
IOS Software system:
cat6k#show etherchannel summary
Flags: D—down P—in port-channel
I—stand-alone s—suspended
H—Hot-standby (LACP only)
R—Layer3 S—Layer2
U—in use f—failed to allocate aggregator
u—unsuitable for bundling
Number of channel-groups in use: 2
Number of aggregators: 2
Group Port-channel Protocol Ports
------+-------------+-----------+------------------------------------
1 Po1(SD) LACP Fa3/13(P) Fa3/14(P) Fa3/15(P) Fa3/16(P)
273 Po273(SD) —
cat6k#
show interfaces etherchannel displays all the interfaces that have been a channel-group
associated with it, regardless of their channel status. If only one interface status is needed,
Vista de pagina 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 50 51

Comentarios a estos manuales

Sin comentarios