Cisco PLE200 Guía de usuario descargar pdf (Pagina 15)

Chapter 5: Using the Configuration Utility

Network

PowerLine AV Ethernet Adapter

Network

The Network screen lists the devices on your HomePlug AV powerline network, all devices with the same

Network Password. (If you have any HomePlug 1.1 or older devices, they will not be detected.)

Status. Displayed here is the MAC address of the Adapter currently accessed by your computer.

The table describes the Adapters on your powerline network.

Device Location. Click once to select this field. Click again to edit it. Enter the location of the Adapter.

MAC Address. Displayed here is the MAC address of the Adapter. L stands for local; this indicates that the Adapter

is physically connected to the computer you are using. R stands for remote; this indicates that the Adapter is

physically connected to another computer or other network device.

Data Rate (Mbps). Displayed here is the transmission speed of the Adapter, except for the one currently accessed

by your computer.

To detect all devices on the powerline network, click the Scan Network button.

To access a specific Adapter, select it on the list and click the Connect button.

To exit the Configuration Utility, click Exit.

Figure 5-2: Network Screen

Figure 5-3: Network Screen with Named Locations

NOTE: If you are adding a new Adapter to a pre-existing powerline network with a unique

Network Password (not the default), then the new Adapter may not be detected. Refer to the

“Security - Device Password” section for instructions.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 33 34

Sin comentarios

Cisco PLE200 Guía de usuario Pagina 15