Cisco ONS 15454 SDH Especificaciones descargar pdf (Pagina 22)

Cisco ONS 15454 SDH Product Overview

Cisco Transport Controller

Cisco ONS 15454 SDH Product Overview, R3.4

September 2002

• Node view—Provides information about the node and displays a graphic of

the ONS 15454 SDH shelf (Figure 10 on page 23). The cards are color-coded

to show the status of the physical cards and ports. This is the default view

displayed each time you log into CTC. You can perform node management

tasks in this view. Figure 10 shows the CTC software in node view.

• Card view—Provides information about individual ONS 15454 SDH cards

and displays a graphic of the selected card. The information that appears and

the tasks you can perform depend on the card. You can perform card and

port-specific maintenance tasks in this view.

The CTC GUI displays tabs and subtabs. From the tabs you can perform all of the

OAM&P tasks. These tasks include provisioning cards, circuits, and rings; creating

protection groups; setting timing parameters; viewing and clearing alarms;

provisioning DCCs; backing up and restoring the database; and troubleshooting,

including creating diagnostic ﬁles and performing loopbacks.

You can ﬁlter the display of circuits in any of the CTC views. Circuits can be ﬁltered

by name, direction, circuit status (active, incomplete, or upgradable), slot, port, type

(high-order circuit, low-order circuit, or low-order tunnel), or size. You can also view

the circuits that belong to a particular span.

Note The FMECs in the upper shelf cannot be preprovisioned.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 55 56

Sin comentarios

Cisco ONS 15454 SDH Especificaciones Pagina 22