Cisco Network Analysis Module 6000 Especificaciones Pagina 88

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 320
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 87
© 2006 Cisco Systems, Inc.
All rights reserved.
Product Features 2-46
NAM / Traffic Analyzer v3.5 Tutorial
© 2006 Cisco Systems, Inc. All rights reserved.
Product Features 2-46
NAM / Traffic Analyzer v3.5 Tutorial
Getting Started
Host Device Parameters - SNMP
Getting Started
Host Device Parameters - SNMP
Setup > Switch Parameters > Switch Information
Information about
the host switch and
available data
sources (VLAN,
NetFlow, NBAR)
Information about
the host switch and
available data
sources (VLAN,
NetFlow, NBAR)
Setup > Router Parameters > Router Information
NAM-1 and NAM-2
NAM-1 and NAM-2
NM-NAM
NM-NAM
Enter the same IP address and
read-write community string as was
configured on the router. Otherwise
the NAM cannot communicate via
SNMP with the router
Enter the same IP address and
read-write community string as was
configured on the router. Otherwise
the NAM cannot communicate via
SNMP with the router
Host Parameters - SNMP
During installation of the NAM-1/2, the NAM is made aware of the SNMP community strings set of the host
switch allowing for the retrieval of mini-RMON information. However, in the case of the NM-NAM, you must
configure the NM-NAM with the community strings configured on the host access router to allow the NM-NAM
to retrieve the MIB-II interface, router health, and NBAR-PD statistics from the router’s SNMP agent. To do
so, enter the Cisco access router’s read-write community strings in the Setup > Router Parameters > Router
Information submenu.
Vista de pagina 87
1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 319 320

Comentarios a estos manuales

Sin comentarios