Cisco UCS B22 M3 Guía para resolver problemas descargar pdf (Pagina 29)

Send document comments to ucs-docfeedbac[email protected]

Cisco UCS B22 Blade Server Installation and Service Note

OL-27513 -01

Removing a Blade Server Cover

Note You must remove the adapter card to service the modular LOM.

To install a modular LOM card on the blade server, follow these steps:

Step 1 Position the modular LOM’s board connector above the motherboard connector and align the captive

screw to the standoff post on the motherboard.

Step 2 Firmly press the modular LOM’s board connector into the motherboard connector.

Step 3 Tighten the captive screw.

Tip Removing a modular LOM is the reverse of installing it. You may find it helpful when removing the

connector from the motherboard to gently rock the board along the length of the connector until it

loosens.

Figure 18 Installing a Modular LOM

332218

1 2 ... 24 25 26 27 28 29 30 31 32 33 34

Sin comentarios

Cisco UCS B22 M3 Guía para resolver problemas Pagina 29