Cisco 1231G - Aironet - Wireless Access Point Especificaciones descargar pdf (Pagina 138)

Chapter 4 Security Setup

Setting Up EAP Authentication

4-26

Cisco Aironet 1200 Series Access Point Software Configuration Guide

OL-2159-01

Step 5 Select the check box for [027] Session-Timeout and enter the number of seconds

for your timeout value in the [027] Session-Timeout entry field.

Step 6 Click Submit + Restart. The timeout value is enabled.

Setting up a Repeater Access Point as a LEAP Client

If you configure your access point as a repeater (an access point not connected to

the wired LAN), you can set up the repeater access point to authenticate to your

network like other wireless client devices. After you provide a network username

and password for the repeater access point, it authenticates to your network using

LEAP, Cisco’s wireless authentication method, and receives and uses dynamic

WEP keys.

See the “Setting Up a Repeater Access Point” section on page 8-1 for instructions

on setting up a repeater access point.

Follow these steps to enable LEAP authentication on a repeater access point:

Step 1 Set up a username and password on your network just as you would for a new user.

The repeater access point will use this username and password to authenticate.

Step 2 Follow this link path to browse to the AP Radio Identification page:

a. On the Summary Status page, click Setup.

b. On the Setup page, click Identification in the AP Radio row under Network

Ports.

Figure 4-9 shows the AP Radio Identification page.

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 271 272

Sin comentarios

Cisco 1231G - Aironet - Wireless Access Point Especificaciones Pagina 138