A. No, the Cisco Aironet AP does not support 802.11f based IAPP. The Cisco Access Points
offer their own robust, feature−rich, and proven inter−Access Point protocol.
Q. What is the use of the bridge−group 1 block−unknown−source
and bridge−group 1 source−learning commands in an AP?
A. Use the bridge−group block−unknown−source configuration interface command to
block traffic from unknown MAC addresses on a specific interface. Use the no form of the
command to disable unknown source blocking on a specific interface.
In order for STP to function properly, block−unknown−source must be disabled for
interfaces that participate in STP.
bridge−group group block−unknown−source
When you enable STP on an interface, block−unknown−source is disabled by default.
The bridge−group 1 source−learning command makes the AP learn the source address of
the client. Use the no form of the command to disable AP from learning the source address of
the client.
Q. Is there a way to prioritize the traffic that flows through the AP so that
traffic from a particular SSID configured on the AP utilizes a higher
bandwidth than the other SSIDs on the same AP?
A. This can be achieved with Quality of Service (QoS) implementation on APs.
Create QoS policies and apply the policies to the VLANs configured on your access
point. These documents explain QoS and how to configure QoS policies on AP.
Wireless Quality−of−Service◊
Configuring QoS on Aironet Access Points◊
♦
Then, map the SSIDs configured on the AP to individual VLANs mentioned. In this
way, if you prioritize the traffic based on VLAN, you can, in turn, prioritize traffic
based on SSID.
♦
Q. Is there a way to limit the maximum number of client devices that can
connect to a single Autonomous Access point?
A. The default behavior of a Cisco client device is that it connects to the AP that has best
signal strength available. But you can limit the clients that can connect to any particular AP
through MAC authentication. You need to provide the MAC address of the client to the AP so
that the AP can allow only those clients and restrict all the other clients that are not part of the
allowed MAC address list from connecting to that particular AP.
Q. From where can you download the latest software?
A. Cisco Aironet equipment operates best when you load all the components with the most
current version of software. Refer to the Cisco Wireless Software Center (
registered customers
only
) in order to download the latest software and drivers.
(100 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales