Cisco DMP100 Guía de usuario descargar pdf (Pagina 29)

A. Wireless

A.1 Software Installation

Software Installation

After the physical connection, Access Point software need to be installed, and the wireless network card driver is optional, which

depends on CSE’s PC.

Overview

AP (Access Point) should be fastened to or placed the visible location in order to the transmission of wireless signal. The front panel

of Access Point should face the direction of the receiver (eg:a notebook etc).

IF need to conﬁgure and manage the Access Point, you should install the software of Wireless LAN Manageme

nt System on the PC

or Notebook that connected with AP, The following driver installation guide uses Windows XP as the presumed operation system.

The procedures and screens in Windows 98se, 2000 are familiar with Windows XP.

Access Point Software Installation

1. Insert the CD-Rom that came with this product to your CD-Rom drive. The setup wizard pops up automatically.

Image A-4

Note: If the CD-Rom fails to auto-run, please click on “My Computer” your CD-Rom Drive then double-click the “Setup” icon to

start the this wizard.

2. Click on “Next”:

Image A-5

3. Select the folder you install and click “Next”

R59770395 FIELD CALIBRATION SOFTWARE (FCS-100) 08/05/09

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 37 38

Sin comentarios

Cisco DMP100 Guía de usuario Pagina 29