Cisco ASA5500-HW - Hardware Accessory Kit Network Device Guía de instalación descargar pdf (Pagina 41)

3-7

Cisco ASA 5500 Series Hardware Installation Guide

78-17374-01

Chapter 3 ASA 5510, ASA 5520, ASA 5540, and ASA 5550

Installing the Chassis

Setting the Chassis on a Desktop

To set the chassis on a desktop, perform the following steps:

Step 1 Locate the rubber feet on the black adhesive strip that shipped with the chassis.

Figure 3-7 Identifying the Rubber Feet

Step 2

Place the chassis upside down, on a smooth, flat surface.

Step 3 Peel off the rubber feet from the black adhesive strip and press them adhesive-side down onto the bottom four

corners of the chassis, see Figure 3-8.

Figure 3-8 Attaching the Rubber Feet

Step 4

Place the chassis right-side up on a flat, smooth, secure surface.

Step 5 Connect the interface cables. See the “Connecting the Interface Cables” section on page 3-8 for more

information.

1 Rubber feet 2 Black adhesive strip

126919

1 Rubber feet

132185

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 81 82

Sin comentarios

Cisco ASA5500-HW - Hardware Accessory Kit Network Device Guía de instalación Pagina 41