Cisco BTS 10200 Guía de instalación descargar pdf (Pagina 31)

CISCO CONFIDENTIAL

Cisco BTS 10200 Softswitch — Release Notes for Release 3.3 V04

OL-1835-04

Caveats

CSCdy37084 Sendevent does not show up in FMG.log Symptom: Sendevent.sh -s 2 -l 2 -i 2 was typed and nothing

appeared in the file FMG.log

Impact: Events do not show up on FMG.log file.

Conditions: Running of test case Event_Management_

NA_SNG_00016 did not work.

Workaround: Issue the command “CLI> subscribe event-report

type=all; severity=all”, then any events issued (either through

normal operation or sendevent.sh) can be seen.

CSCdy46844 “Cannot receive SIP messages from

network” alarm does not clear

Symptom: BTS 10200 software version 3.3 does not properly

clear “Cannot receive SIP messages from network” alarms.

Impact: If the alarm remains on after the port conflict has been

resolved and the process that issued the alarm has been

successfully restarted, there is no direct service impact.

Conditions: This alarm is issued when the a process using the

SIP stack cannot open the port it is configured to use. This can

happen if the BTS is not configured properly, or if some other

program running on the BTS is using the port that the process is

configured to use.

If a process that uses the SIP stack cannot open the port it is

configured to receive messages on, it will issue this alarm and

exit. In order to get the system to work properly, the port conflict

must be resolved and the process must be restarted.

Workaround: Follow the steps described in the alarm

description to remove any port conflicts.

Before restarting the call agent, use the CLI to manually clear

the alarm. Then restart the call agent and verify the alarm is not

issued again.

The current alarm description does not tell the operator to clear

the alarm.

CSCdy47391 Unable to display all sub /trunk

termination status via COBRA interface

Symptom: When user inputs ID for all subscribers id=*@mgw,

EPOM came up with error: java.lang.NullPointerException

Impact: Cannot view all subscribers using EPOM.

Conditions: Current EPOM is able to display individual CIC for

a specified trunk group when the user selects to view

trunk-termination status. However, it failed to display for all

CICs in a trunk group.

Workaround: Use CLI command to view all subscribers,

Table 2 Open Caveats (continued)

DDTS ID Description Workaround

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 59 60

Comentarios a estos manuales

Sin comentarios

Cisco BTS 10200 Guía de instalación Pagina 31

Comentarios a estos manuales