Cisco BTS 10200 Guía de instalación descargar pdf (Pagina 6)

CISCO CONFIDENTIAL

Cisco BTS 10200 Softswitch — Release Notes for Release 3.3 V04

OL-1835-04

New and Changed Information

Provisioning the Cisco BTS 10200 Softswitch to Generate EMs

These steps provision the Cisco BTS 10200 Softswitch to generate EMs.

Note The value for id shown in this section (CA146) is an example.

Step 1 Login to a CLI session on the Cisco BTS 10200 Softswitch.

Step 2 Use the following command to display the current values for the call-agent-profile table:

show call-agent-profile id=CA146;

where:

• id—Domain name of the specific Call Agent (CA), in the format CAnnn, where nnn = 3-digit

number previously assigned to the CA. This value is case-sensitive (for example, CA146 and ca146

are not the same). This is the unique identifier for this Call Agent (CMS) node, which was

permanently assigned at time of software installation on the Cisco BTS 10200 Softswitch.

Step 3 If the system response indicates that this table does not exist, then you must create it using the following

command. Otherwise, the EM function is not supported and EMs will not be generated.

add call-agent-profile id=CA146; cdb-billing-supp=N; em-billing-supp=Y;

Caution If the call-agent-configuration table is not created, the Cisco BTS 10200 Softswitch will generate CDBs

but not EMs.

Step 4 If the call-agent-profile table already exists, check (in the display from Step 2) to see if cdb-billing-supp

is set to N (no) and em-billing-supp is set to Y (yes). If not already shown in the display, enable EM

billing support by entering the following command:

change call-agent-profile id=CA146; cdb-billing-supp=N; em-billing-supp=Y;

where:

• cdb-billing-supp—Specifies whether to generate Call Detail Blocks (CDBs). The value of this

optional token is a single ASCII character (Y or N); the default value is Y (yes). The value of this

token must be set to N (no) if the Cisco BTS 10200 Softswitch is to provide event message

generation.

• em-billing-supp—Specifies whether to generate PacketCable event messages. The value of this

optional token is a single ASCII character (Y or N); the default value is N (no). The value of this

token must be set to Y (yes) if the Cisco BTS 10200 Softswitch is to provide event message

generation.

Caution Be sure the system is configured to generate either EMs, and not CDBs. Attempting to generate both

types of records simultaneously can significantly degrade the call processing rate.

Step 5 Enter the following command to generate EMs based on CMS and MGC logical network elements, and

to specify the financial entity ID.

1 2 3 4 5 6 7 8 9 10 11 ... 59 60

Sin comentarios

Cisco BTS 10200 Guía de instalación Pagina 6