Cisco DPA 7610 Manual de usuario descargar pdf (Pagina 16)

Documentation Errata

Cisco DPA 7630/7610 Voice Mail Gateway Version 1.2(1) Release Notes

78-12814-02 Rev. B0

Network Management Protocols

The following section modifies the “Network Management Protocols” section on

page 1-6 of the Cisco DPA 7630/7610 Voice Mail Gateways Administration

Guide.

The DPA 7630/7610 supports an additional DPA-specific Cisco MIB in version

1.2(1). The MIB OID is: CALISTA-DPA-MIB.

For an explanation of this MIB, refer to the SNMP v2 MIBs available at the

following location:

http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml

Setting Dialing Sequence for Message Waiting Indicator

The following section modifies the “Setting Dialing Sequence for Message

Waiting Indicator” section on page 3-14 and the “Entering Dialing Sequences for

MWI Activation on DPA 7630” on page 4-13 of the Cisco DPA 7630/7610 Voice

Mail Gateways Administration Guide.

The dialing sequence can also optionally include a comma (,) to indicate a pause

of 200 milliseconds (ms). These are additive, so a series of four commas (,,,,) is

an 800 ms pause. Each pause causes the DPA 7630 to wait an additional 200 ms

while receiving MWI commands from the Octel system, and also creates a 200 ms

delay while sending the command on to the PBX.

For example, if you enter #40,,,,, as the dialing sequence, the DPA 7630 waits an

additional second for MWI commands. The DPA 7630 also inserts a 1 second

pause when dialing the command to the PBX (after dialing #40 and before dialing

the extension number).

1 2 ... 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Cisco DPA 7610 Manual de usuario Pagina 16