Cisco TANDBERG?150MXP Manual de usuario descargar pdf (Pagina 44)

TANDBERG TANDBERG and Cisco CallManager

D13907.01

8 TANDBERG MPS and Cisco CallManager

A Multipoint Control Unit (MCU) is used for combining multiple video and/or audio streams together into

the same conference to aid in the collaboration amongst many different remote sites. In a multipoint

conference all the endpoints connect to the MCU; the MCU will transmit the voice and video to all

participants, the layout on this video stream depends on the configurations of the MCU.

The TANDBERG MPS is an MCU for Enterprises and Service providers. The capacity on the MPS is up

to 40 conferences and a total of 160 site connections. The recourses on the MPS can be used for

conference calls with H.323 endpoints, SIP endpoints, H.320 endpoints, SCCP endpoints or a conference

with a mix of all these endpoints. Through the H.225 trunk established earlier, any SCCP endpoint can

now join any H.323 MCU (or H.320 MCU by way of the gateway).

Figure 10 shows an illustration of the SCCP network connected to a H.323 network with a TANDBERG

MPS.

Figure 10: TANDBERG MPS and the Cisco CallManager

Note: The SCCP clients will not be able to utilize all the H.323 feature supported by the MPS but it will

send and receive audio and the main video stream.

For more information about the TANDBERG MPS, reference document D13373 MPS User Manual.

CallManager

T1000 MXP SCCP

T770 MXP SCCP

SCCP network

H.323 network

Trunk

TANDBERG MPS

Gatekeeper

PSTN

1 2 ... 39 40 41 42 43 44 45 46

Sin comentarios

Cisco TANDBERG?150MXP Manual de usuario Pagina 44