Cisco 3200 Series Manual de usuario descargar pdf (Pagina 41)

3-5

Cisco 3200 Series Router Hardware Upgrade Guide

OL-15983-01

Chapter 3 Replacing Cards in the Cisco ISR 3270 Rugged Enclosure

Card Replacement Process

Removing the Wiring Card

To remove the wiring card, follow these steps:

Step 1 Disconnect all cables from the wiring card.

Step 2 Using a Phillips screwdriver, remove (torque 5.5 to 5.7 in-lb) the 7 or 8 wiring card screws, as shown in

Figure 3-4.

Figure 3-4 Removing the Wiring Card Screws

Step 3 In the case of a 0-WMIC configuration, remove screw #2 which is not used.

Step 4 Remove the wiring card.

Removing the Card Stack

To remove the card stack, follow these steps:

Step 1 Using a Phillips screwdriver, loosen the screws of the two alignment tabs that hold the card stack to the

extrusion.

Step 2 Remove the two alignment tabs.

Step 3 Loosen the 16 Wedge Loks (14 on the I/O end cap side and 2 on the antenna end cap side) that are holding

the card stack in place, using a 3/32-in hex blade to release the clamping mechanism, as shown in

Figure 3-10.

270468

1 Wiring screws

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 59 60

Sin comentarios

Cisco 3200 Series Manual de usuario Pagina 41