Cisco MDS 9200 Series Guía de instalación descargar pdf (Pagina 105)

3-9

Cisco MDS 9200 Series Hardware Installation Guide

OL-16188-01

Chapter 3 Connecting the Cisco MDS 9200 Series

Connecting to a Fibre Channel Port

Note Use only Cisco SFP transceivers on the Cisco MDS 9200 Series. Each Cisco SFP transceiver is encoded

with model information that enables the switch to verify that the SFP transceiver meets the requirements

for the switch. For instructions specific to the transceiver type, see the “SFP Transceiver Specifications”

section on page B-9.

The Cisco MDS 9000 Family supports SFP transceivers with the following two types of latching devices:

• Mylar tab latch (Figure 3-5)

• Bale-clasp latch (Figure 3-6)

Figure 3-5 SFP Transceiver with Mylar Tab Latch

Figure 3-6 SFP Transceiver with Bale-Clasp Latch

Installing an SFP Transceiver

To install an SFP transceiver, follow these steps:

Step 1 Attach an ESD-preventive wrist strap and follow its instructions for use.

Step 2 Remove the dust cover from the port cage.

Step 3 Remove the dust cover from the port end of the transceiver.

Step 4 Insert the transceiver into the port:

• If the transceiver has a Mylar tab, orient the transceiver with the tab on the bottom, and then gently

insert the transceiver into the port until it clicks into place.

• If the transceiver has a bale clasp, orient the transceiver with the clasp on the bottom, close the clasp

by pushing it up over the transceiver, and then gently insert the transceiver into the port until it clicks

into place.

Caution If the transceiver does not install easily, ensure that it is correctly oriented and the tab or clasp

are in the correct position before continuing.

63065

63067

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 163 164

Sin comentarios

Cisco MDS 9200 Series Guía de instalación Pagina 105