Cisco 1417 - 1417 Router - EN Manual de usuario descargar pdf (Pagina 5)

Install the Router (continued)

C. Connect a PC to the router

To use Cisco IOS software to conﬁgure the router, it must be connected to a terminal or to a

PC with terminal-emulation software. Terminal-emulation software should be conﬁgured with

the following settings: 9600 baud, 8 data bits, no parity bits, and 1 stop bit.

Take the following steps to connect the router to one of these devices:

Step 1 Connect one end of the blue console cable (included) to the CONSOLE port on the

router rear panel.

Step 2 Depending on the console port connector (DB-25 or DB-9) on your terminal or PC,

connect one of the gray adapters (included) to the other end of the console cable.

Step 3 Connect the gray adapter to the DB-25 or DB-9 connector on your terminal or PC.

Cisco 1417

CONSOLE

ADSL

ETHERNET

LNK

OK FLASH PC CARD

17501

Console cable

To PC or terminal

1 2 3 4 5 6 7 8

Sin comentarios

Cisco 1417 - 1417 Router - EN Manual de usuario Pagina 5