Cisco 1417 - 1417 Router - EN Manual de usuario descargar pdf (Pagina 15)

Installation 2-15

Verifying Your Installation

You can verify that you have correctly installed the router by checking the following LEDs:

Table 2-1 Using LEDs to Verify Installation

Installing a Flash PC Card

The Flash PC card is a writable card used to download new software to the router.

Note Although the router is shipped from Cisco with the Flash PC card already installed,

you might have to install it if someone has removed the card for any reason. For example,

to conﬁgure your router, the system administrator might remove the card, add a

conﬁguration ﬁle to it, then return it to you.

LED (Location) What to Look for

PWR (front) On steady when power is being supplied to the router.

OK (front) • One blink per second when the router is in ROM monitor

mode.

• Several blinks per second when the router is running the boot

image in ROM monitor.

• On steady when the Cisco IOS software is loaded and

functional.

ETHERNET ACT (front) Blinking when there is network trafﬁc on the local Ethernet

network.

LNK (rear) On steady when the router is correctly connected to the local

Ethernet network through the Ethernet port.

WAN CARRIER On steady when the router has synchronized with the equipment

connected to the ATM-25 port (Cisco 1401 router) or with the

ADSL equipment at the service provider’s central ofﬁce

(Cisco 1407 router).

OK (rear) On steady when the Flash PC card is correctly installed in the

router. If this LED is off, reinstall the card according the

following section, “Installing a Flash PC Card.”

1 2 ... 10 11 12 13 14 15 16

Sin comentarios

Cisco 1417 - 1417 Router - EN Manual de usuario Pagina 15