Cisco 1417 - 1417 Router - EN Manual de usuario descargar pdf (Pagina 16)

Installing a Flash PC Card

Cisco 1400 Series Router Installation and Configuration Guide

2-16

You can perform these steps while the router is operating. Follow these steps, and refer to

Figure 2-10 to install the Flash PC card:

Step 1 Insert the connector end of the card in the router slot, aligning the card edges

along the card-slot guides, and push the Flash PC card into the slot until the card

is seated.

When the card is completely seated in the connector, the blue button left of the

Flash PC card slot pops out. If the blue button does not pop out, the card is not

seated. Press the blue button, remove the card, and reinsert it.

Step 2 Verify that the OK LED (to the left of the card slot) is lit steadily, which indicates

that the card is inserted and functioning correctly. If the LED is not on, reinstall

the card.

If you cannot successfully install the card, contact your Cisco reseller.

Note Figure 2-5 shows a Cisco 1401 router; however, this step is the same for all

Cisco 1400 series routers.

Figure 2-10 Installing a Flash PC Card

12682

Cisco 1401

CONSOLE

ATM 25

ETHERNET

LNK

OK FLASH PC CARD

Flash

PC card

OK LED

Blue plastic

eject button

Flash PC card slot

Flash PC card

1 2 ... 11 12 13 14 15 16

Sin comentarios

Cisco 1417 - 1417 Router - EN Manual de usuario Pagina 16