Cisco 1605R Guía de instalación descargar pdf (Pagina 41)

Installing WAN and Voice Interface Cards in a Cisco Modular Router 2-7

Installing a WAN or Voice Interface Card in a Network Module or Chassis Slot

The following warning applies to routers that use a DC power supply.

Note If you are installing a single WAN interface card in a Cisco 2600 series

router, use slot W0 ﬁrst. (See Figure 2-3.)

TheCisco 2600 series routerﬁrst checks slot W0before it checks slotW1. If you

ﬁll slot W1 while leaving slot W0 vacant, your router conﬁguration could be

affected.

Step 2 Using either a number 2 Phillips screwdriver or a small ﬂat-blade screwdriver to

remove the blank ﬁller panel from the network module slot or chassis card slot

where you plan to install the card. Save the ﬁller panel for future use.

Note The voice network module slots are numbered V0, on the right, and V1,

on the left.

Step 3 Align the card with the guides in the two-slot network module or WAN interface

card slot and slide it gently into the slot. (Figure 2-4 shows a 1-port serial WAN

interface card.)

Step 4 Push the card into place until you feel its edge connector mate securely with the

connector in the two-slot network module or WAN interface card slot.

Step 5 Fasten the card’s captive mounting screws into the holes in the network module

faceplateorWANinterfacecardslot, using thePhillips or ﬂat-blade screwdriver.

Step 6 If the router was previously running, reinstall the network interface cables and

turn ON power to the router.

Warning Before performing any of the following procedures, ensure that power is

removed from the DC circuit. To ensure that all power is OFF, locate the circuit breaker

on the panel board that services the DC circuit, switch the circuit breaker to the OFF

position, and tape the switch handle of the circuit breaker in the OFF position.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 81 82

Sin comentarios

Cisco 1605R Guía de instalación Pagina 41