Cisco 1700 Series Especificaciones descargar pdf (Pagina 72)

Chapter 5 Configuring ISDN

Dial-Up ISDN Connection to a Central-Site Router

5-14

Cisco 1700 Series Router Software Configuration Guide

78-5407-03

For the second verification procedure, perform these steps:

Step 1 From the privileged EXEC command mode, confirm that the ISDN line is

connected to the remote site by entering the ping command, followed by the IP

address of the central-site router:

Router# ping 192.168.37.40

Step 2 Enter the show interface virtual-access 1 command.

Step 3 Confirm that the “Open: IPCP” message appears in the command output:

Router# show interface virtual-access 1

Virtual-Access1 is up, line protocol is up

Hardware is Virtual Access interface

MTU 1500 bytes, BW 64 Kbit, DLY 100000 usec, rely 255/255, load

1/255

Encapsulation PPP, loopback not set, keepalive set (10 sec)

DTR is pulsed for 5 seconds on reset

LCP Open, multilink Open

Open: IPCP

Last input 00:00:01, output never, output hang never

Last clearing of "show interface" counters 00:54:41

Queueing strategy: fifo

Output queue 0/40, 0 drops; input queue 0/75, 0 drops

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

708 packets input, 150742 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

709 packets output, 157653 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 output buffer failures, 0 output buffers swapped out

0 carrier transitions

Step 4 To continue configuration, reenter global configuration mode.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 257 258

Sin comentarios

Cisco 1700 Series Especificaciones Pagina 72