Cisco 2501 - Router - EN Manual de usuario descargar pdf (Pagina 47)

Viewing, Saving, and Erasing Configurations

225

Viewing, Saving, and Erasing

Configurations

If you run through setup mode, you’ll be asked if you want to use the configuration you just

created. If you say yes, then it will copy the configuration running in DRAM (known as the

running-config) into NVRAM and name the file startup-config. Hopefully, you always will

use the CLI or SDM and not setup mode.

You can manually save the file from DRAM to NVRAM by using the copy running-

config startup-config command (you can use the shortcut copy run start):

Todd#copy running-config startup-config

Destination filename [startup-config]? [press enter]

Building configuration...

[OK]

Todd#

Building configuration...

When you see a question with an answer in [], it means that if you just press Enter, you’re

choosing the default answer.

Also, when the command asks for the destination filename, the default answer is startup-

config. The reason it asks is because you can copy the configuration pretty much anywhere

you want. Take a look:

Todd#copy running-config ?

archive: Copy to archive: file system

flash: Copy to flash: file system

ftp: Copy to ftp: file system

http: Copy to http: file system

https: Copy to https: file system

ips-sdf Update (merge with) IPS signature configuration

null: Copy to null: file system

nvram: Copy to nvram: file system

rcp: Copy to rcp: file system

running-config Update (merge with) current system configuration

scp: Copy to scp: file system

startup-config Copy to startup configuration

syslog: Copy to syslog: file system

system: Copy to system: file system

tftp: Copy to tftp: file system

xmodem: Copy to xmodem: file system

ymodem: Copy to ymodem: file system

47020.book Page 225 Wednesday, January 2, 2008 4:31 PM

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 75 76

Sin comentarios

Cisco 2501 - Router - EN Manual de usuario Pagina 47