Cisco 2516 Manual de usuario descargar pdf (Pagina 22)

22 Release Notes for Cisco IOS Release 11.2(11) Software Feature Packs for Cisco 2500 Series Routers

Related Documentation

Step 21 When prompted, enter the ﬁlename of the Cisco IOS Release 11.2 image to be copied to

the router, as in the following example:

Source file name? 80031718.bin

This example speciﬁes the DOS image name of the IP feature set for Cisco 2500 series

routers (as shown in Table 2 in the section, “Cisco Feature Pack and Memory

Descriptions”).

Step 22 In response to the prompt, enter the destination UNIX image ﬁlename, and press Enter.

This is the name of the image ﬁle on the router, not the full pathname of the image on the

CD-ROM attached to the PC. Refer to Table 2 in the section, “Cisco Feature Pack and

Memory Descriptions” for the UNIX image ﬁlename.

Destination file name [80031718.bin]? c2500-i-l

During the transfer process, the software displays messages indicating that it has accessed

the ﬁle you have speciﬁed and is loading it.

Step 23 Enter yes in response to the prompt asking if you want to erase the existing image copy

resident in the router Flash memory before copying the new one.

Erase flash device before writing? [confirm] yes

The entire copying process takes several minutes and differs from network to network.

The exclamation point (!) indicates that the copy process is taking place. Each

exclamation point (!) indicates that ten packets have been transferred successfully. A

checksum veriﬁcation of the image occurs after the image is written to Flash memory.

Step 24 Enter the following commands to reset the conﬁguration register to 0x2102.

Router(boot)(config)# config terminal

Router(boot)(config)# config-reg 0x2102

Router(boot)(config)# end

Step 25 Enter the reload command to reload the router:

Router# reload

After reload is complete, the router should be running the required Cisco IOS image. Use the

show version command to verify.

Related Documentation

For a list of documentation related to the Cisco 2500, refer to the Release Notes for the 2500 Series

for Cisco IOS Release 11.2P. Release notes and other Cisco documentation are on the Cisco

Documentation CD-ROM and at Cisco Connection Online (CCO) on the World Wide Web:

• On the Documentation CD-ROM, go to Cisco Product Documentation, select Cisco IOS

Software Conﬁguration, and then select Cisco IOS Release 11.2.

• On CCO, go to http://www.cisco.com/, click on Software and Support, and select

Documentation. Next, select Documentation,gotoCisco IOS Software Conﬁguration, and then

click on Cisco IOS Release 11.2.

Caution If you upgraded a CiscoPro CPA2500 router, do not save the conﬁguration when

prompted.

1 2 ... 17 18 19 20 21 22 23 24 25 26

Sin comentarios

Cisco 2516 Manual de usuario Pagina 22