Cisco 2520-RF - 2520 Router Especificaciones descargar pdf (Pagina 47)

Installing the Router 3-11

Connecting the DC Power Supply

Warning When stranded wiring is required, use approved wiring terminations, such as

closed-loop or spade-type with upturned lugs. These terminations should be the appropriate

size for the wires and should clamp both the insulation and conductor. (To see translated

versions of this warning, refer to the Regulatory Compliance and Safety Information

document that accompanied the router.)

Caution Do not overtorque the terminal block captive thumbscrew or terminal block

contact screws. The recommended torque is 8.2 ± 0.4 inch-lb.

Warning After wiring the DC power supply, remove the tape from the circuit breaker

switch handle and reinstate power by moving the handle of the circuit breaker to the on

position. (To see translated versions of this warning, refer to the Regulatory Compliance

and Safety Information document that accompanied the router.)

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 115 116

Sin comentarios

Cisco 2520-RF - 2520 Router Especificaciones Pagina 47