Cisco 3002 - VPN Hardware Client Especificaciones descargar pdf (Pagina 145)

11-7

VPN 3002 Hardware Client Reference, Release 4.0

OL-3813-01

Chapter 11 Policy Management

Configuration | Policy Management | Traffic Management | PAT | Enable

Configuration | Policy Management | Traffic Management | PAT

| Enable

This screen lets you enable or disable PAT, which applies PAT to all configured traffic traveling from the

private interface to the public interface.

Figure 11-4 Configuration | Policy Management | Traffic Management | PAT | Enable Screen

PAT Enabled

Check the box to enable Client Mode (PAT), or clear it to enable Network Extension Mode.

Note Remember that to use Network Extension Mode, you must configure an IP address other than the

default for the private interface. If you do not change the IP address of the private interface, you can

not disable PAT.

Apply/Cancel

To enable or disable PAT, and include your setting in the active configuration, click Apply. The Manager

returns to the Configuration | Policy Management | Traffic Management | PAT screen.

Reminder:

To save the active configuration and make it the boot configuration, click the Save Needed icon at the

top of the Manager window.

To discard your entry and leave the active configuration unchanged, click Cancel. The Manager returns

to the Configuration | Policy Management | Traffic Management | PAT screen.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 317 318

Sin comentarios

Cisco 3002 - VPN Hardware Client Especificaciones Pagina 145