Cisco 3002 - VPN Hardware Client Manual de usuario descargar pdf (Pagina 11)

Release Notes for Cisco VPN 3002 Hardware Client Release 3.5.2

78-13971-02

Caveats

• CSCdv50669

If there are more than 150 networks in a network list used for split tunneling

on the central site VPN Concentrator, when a VPN 3002 connects to the VPN

Concentrator using this group and attempts to establish an SA to all of the

networks within that network list, it may cause a reboot. We recommend that

a network list that applies to a VPN 3002 contain 150 or fewer networks.

• CSCdv66367

The VPN 3002 experiences an exception when the static route, default route,

or interface setting is deleted/modified.

• CSCdv69320

With an active tunnel between a VPN 3002 and VPN Concentrator,

occasionally the event

IPSec input- discarding pkt with no NAT Rule

displays. No negative operational issues have been noted when this happens.

• CSCdv72871

VPN 3002 does not accept a DHCP address when the relay device sets

unicast_ DHCPOFFER packet with the BROADCAST flag SET.

• CSCdv85725

When using Challenge-based authentication such as New PIN mode for SDI,

the command-line interface does not present the question or reply text. The

workaround is to use the HTML interface.

• CSCdv86086

The Nexland router has problems with IKE Phase-1 rekeying. When this

happens the 3002 tunnel disconnects. Data movement brings up the tunnel

again.

• CSCdw20486

The Cisco SoundStation Premier (Polycom IP Speaker Phone) is unable to get

a valid DHCP IP Lease from the 3002s integrated DHCP server.

• CSCdw47278

If the public interface uses PPPoE and the peer address is entered as a name

rather than an IP address, DNS resolution fails; therefore the tunnel does not

establish.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Sin comentarios

Cisco 3002 - VPN Hardware Client Manual de usuario Pagina 11