Cisco 3631 Guía de instalación descargar pdf (Pagina 26)

Upgrading System Memory in Cisco 3700 Series Routers

OL-5423-02

Upgrading System Memory in Cisco 3745 Routers

Figure 14 Captive Screws on a Cisco 3745 Router

Step 7

Reinstall the chassis on a rack or desktop.

Step 8 Proceed to the “Replacing Connections to the Router” section on page 26.

Replacing Connections to the Router

To make final connections to the router, follow these steps:

Step 1 Replace all network connections.

Step 2 Do one of the following:

• AC-powered router: Plug the power cord into a 3-terminal, single-phase power source that

provides power within the acceptable range (100 to 240 VAC, 50 to 60 Hz).

• DC-powered router: Remove the tape from the circuit breaker switch handle and reinstate power

by moving the handle of the circuit breaker to the ON position.

Step 3 Turn ON the power switch. The power LED on the front panel of the router should come on.

Step 4 Check the Sys LED on the right side of the front panel to verify that it goes on after a few seconds delay

when booting.

Step 5 If you have problems, see the “Obtaining Technical Assistance” section on page 28.

Step 6 Proceed to the “Recovering Compact Flash Memory and System Images” section on page 27.

72114

1 2 ... 21 22 23 24 25 26 27 28 29 30

Sin comentarios

Cisco 3631 Guía de instalación Pagina 26