Cisco 3800 Series Guía de instalación descargar pdf (Pagina 4)

Cisco 3800 Series Integrated Services Routers: Overview

OL-6339-01

Performing the Initial Configuration

http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm

You should consult the SDM release notes to determine whether SDM is supported for the router on

which you want to install it.

If the following messages appear at the end of the startup sequence, SDM is installed on your router:

yourname con0 is now available

Press RETURN to get started.

Tip If these messages do not appear, SDM was not shipped with your router. If you want to use SDM, you

can download the latest version of SDM and instructions for installing it on your router from the

following URL:

http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm

To obtain the SDM quick start guide, release notes, and other SDM documentation, go to

http://www.cisco.com/go/sdm, and click the Technical Documentation link.

For instructions on configuring your router by using SDM, see the Cisco Router and Security Device

Manager (SDM) Quick Start Guide.

Initial Configuration Using the Setup Command Facility

This section shows how to use the setup command facility to configure a hostname for the router, set

passwords, and configure an interface for communicating with the management network.

If the following messages appear at the end of the startup sequence, the setup command facility has been

invoked automatically:

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to enter the initial configuration dialog? [yes/no]:

The setup command facility prompts you for basic information about your router and network, and it

creates an initial configuration file. After the configuration file is created, you can use the CLI or

Security Device Manager to perform additional configuration.

The prompts in the setup command facility vary, depending on the particular router platform, the

installed interface modules, and the software image. The following example and the user entries (in

bold) are shown as examples only.

To perform initial configuration using the setup command facility, follow these steps in privileged EXEC

mode.

Note If you make a mistake while using the setup command facility, you can exit and run the setup command

facility again. Press Ctrl-C, and enter the setup command at the privileged EXEC mode prompt

(Router#).

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Cisco 3800 Series Guía de instalación Pagina 4