Cisco 678 Especificaciones Pagina 102

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 192
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 101
Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Configure Applications
5-18
Cisco 600 Series Installation and Operation Guide
78-11190-01
Configure Applications
The Cisco 67x supports these applications for system management and control:
DHCP client
DHCP server
NAT
RADIUS client
SNMP
SYSLOG client
Telnet server
TFTP server
Web server (HTTP server)
DHCP Client
The DHCP client requests an IP address from a DHCP server. To enable the DHCP
client:
Note
Enabling the DHCP client automatically disables the DHCP server
on the CPE.
Step 1
Enable the DHCP client:
set dhcp client enabled
Step 2
To change the DHCP client interface, enter:
set dhcp client interface eth0
Step 3
To check whether this feature is enabled, enter:
show dhcp client
Step 4
Write the changes to NVRAM:
write
Vista de pagina 101
1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 191 192

Comentarios a estos manuales

Sin comentarios